We build cables for life

Cables with LSZH sheath need to be handled with care during Installation. Since Special additives are used in the formulation of LSF compound to give the typical flame retardant characteristics of Halogen free polymers (Ex. High Oxygen Index, very Low smoke density, no acid gas liberation and retardance to flame propagation) some mechanical properties deteriorates. The following points shall be noted

Cable shall not be exposed to sunlight for considerable for considerable period before installation i.e., the temperature of sheath should be below 40°C
Preferably the installation is done when the ambient temperature is low.
Wire/Rope should not be used directly on cable sheath for pullying
The cable should not be bend more than the specified Minimum Bending radius.
When pulled on cable trays/or any uneven surface, special attention is needed to weldings/ or unusually rough terrains
Rollers and bends should not have any sharpness which may damage sheath
Special LSZH compatible accessories and fixings are recommended for installations requiring enhanced fire performance.

The site chosen for storage of cable drums must be level and dry. It should have a firm, preferably concreted surface. This will avoid sinking of the drums and difficulty in subsequent shifting.
All drums should be stored in such a manner as to leave sufficient space between them for air circulation.

During storage, the drum should be rolled to an angle of 90 once every three months. Also, tie bolts shall be checked and tightened at regular intervals.
Always turn a cable drum using turn table. Never use crow bar if turn table is not available. Two well greased plates can be used instead.

Storage of cable drums under shed is not essential unless the storage is for very long period. However, the cable drums shall be protected from direct sunlight by covering them by tarpaulin or thick black polyethylene sheet.